DVTELL Ioimage trk-101 Manual de Instalação

Consulte online ou descarregue Manual de Instalação para Redes DVTELL Ioimage trk-101. DVTELL Ioimage trk-101 Installation manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 0
Installation
Manual
trk-101
Ver. A1 Jan 2013
The contents of this guide may
not be reproduced or reprinted
in whole or in part without the
express written permission of
DVTEL, INC.
DVTEL INC.
65 Challenger Road
Ridgefield Park, NJ 07660
Vista de página 0
1 2 3 4 5 6 ... 31 32

Resumo do Conteúdo

Página 1

Installation Manual trk-101 Ver. A1 Jan 2013 The contents of this guide may not b

Página 2 - Table of Contents

Introduction 2 2.1 Items Included in the Package The unit package contains the following items: QTY Description 1 trk-101 unit 1 Mountin

Página 3

Introduction 3 Item Description Alarm Input Single alarm input connection (a set of two wires) from an external device — for example, a fire sen

Página 4 - Document Information

Introduction 4 2.2.2 Video Connection Panel The following is a description of the video connection panel of the unit. Figure 4: trk-101

Página 5 - Document Conventions

Installing and Connecting the Unit 5 Installing and Connecting the Unit This section describes how to install and connect the unit and includes

Página 6

Installing and Connecting the Unit 6 3.1.1 Assembling the Unit in a Rack Mount Panel (Optional Accessory) Up to 10 units can be mounted

Página 7 - Preventing EMI and RFI

Installing and Connecting the Unit 7 3. Fasten each unit using the nuts and washers removed in step 1, making sure to first place the washer on

Página 8 - Site Preparation

Installing and Connecting the Unit 8 To power to the unit using a power outlet: 1. Connect the AC adaptor output to the terminal block o

Página 9 - Introduction

Installing and Connecting the Unit 9 To change the unit’s IP address: 1. Insert the CD included in the package in your computer’s disk drive. 2

Página 10 - 2.2 Hardware Description

Installing and Connecting the Unit 10 To connect a video source to the unit: 1. Securely connect the video cable connector (BNC) to the

Página 11

Installing and Connecting the Unit 11 The analog Video Output (composite video) contains the video from the camera combined with On-Screen Displ

Página 12 - Description

Installation Manual - sc1dn-A ii Table of Contents Document Information ...

Página 13 - 3.1 Installing the Unit

Installing and Connecting the Unit 12 For more information on incident responses and relay outputs, refer to the HTML Edition Units User’

Página 14

Installing and Connecting the Unit 13 3.3.1 Hard Reset Using the Reset Button The unit has a Reset button located on the power connection pane

Página 16

Installation Manual - sc1dn-A 15 Appendix The appendix contains the following sections:  trk-101 Specifications (page 16)  Connectin

Página 17

Appendix 16 A.1. trk-101 Specifications The following are the trk-101 unit’s specifications: Video Input channels Number of Intelligent Vi

Página 18

Appendix 17 Environmental Specifications Operating Temperature 0° to 50°C (32° to 122°F) Operating Humidity 5% to 95% (non-condensing) Certific

Página 19

Appendix 18 A.2. Connecting Leads to a Spring Clamp Terminal Block The unit is delivered with two terminal block connectors. The connector

Página 20 - 3.3 Resetting the Unit

Appendix 19 A.3. Night Mode Max FPS A new setting, Night Mode Max FPS, has been added to the Setup>Camera>Video Settings>Advanced tab.

Página 21 - 3.4 Night Mode Max FPS

Appendix 20 The actual encoder FPS will be the lower of the sensor FPS setting or the encoder FPS setting. The following table illustrates

Página 22

Appendix 21 A.4. Troubleshooting This section provides useful information and remedies for common situations where problems may be encountered.

Página 23 - Appendix

Document Information iii List of Figures Figure 1: trk-101 Unit ...

Página 24 - A.1. trk-101 Specifications

Appendix 22 Problem Possible Solution Bad output video quality  Check the source video signal quality by connecting an analog monitor t

Página 25 - 17

Appendix 23 A.5. N/O to N/C Relay Configuration The on-board relay in the trk-101 provides a single contact which is by default Normally Open (N

Página 26

Contacting DVTEL 24 Contacting DVTEL To contact us, write us at [email protected], or contact your local office: CORPORATE HEADQUARTERS DVTEL

Página 27 - A.3. Night Mode Max FPS

Document Information iv Document Information Document Scope and Purpose The purpose of this document is to provide instructions and insta

Página 28 - Appendix

Document Information v Disclaimer Users of DVTEL products accept full responsibility for ensuring the suitability and considering the role of th

Página 29 - A.4. Troubleshooting

Document Information vi Warning: The unit cover is an essential part of the product. Do not open or remove this cover. Never operate

Página 30

Document Information vii Warning: Assure the connected electrical power source uses a circuit breaker or fuse no larger than 120 VAC, 15A or 2

Página 31

Document Information viii Site Preparation There are several requirements that should be properly addressed prior to installation at the

Página 32 - Contacting DVTEL

Installation Manual - sc1dn-A 1 Introduction The trk-101 is a self-contained video analytic encoder that monitors the video input video

Comentários a estes Manuais

Sem comentários